Firmware
ARK Flow MR runs the PX4 DroneCAN Firmware. As such, it supports firmware update over the CAN bus and dynamic node allocation.
The flight controller flashes the node firmware over CAN.
Firmware target:
ark_can-flow-mr_defaultBootloader target:
ark_can-flow-mr_canbootloader
Downloads
Node Parameters
Set these on the ARK Flow MR, then reboot it. Use QGroundControl, where each CAN node is a separate Component X under Vehicle Settings > Parameters, or the DroneCAN GUI Tool. Defaults are those of the firmware above.
CANNODE_TERM
0
Set to 1 on the last node of the CAN bus
CANNODE_PUB_IMU
0
Set to 1 to publish RawIMU messages on the CAN bus. PX4 also needs UAVCAN_SUB_IMU set to 1
SENS_AFBR_MODE
1
Distance sensor measurement mode. 0 short range, 1 long range, 2 high speed short range, 3 high speed long range
SENS_AFBR_S_RATE
25
Distance sensor measurement rate in Hz below the switching distance
SENS_AFBR_L_RATE
5
Distance sensor measurement rate in Hz above the switching distance
SENS_AFBR_THRESH
4
Switching distance in m. The rate changes to SENS_AFBR_L_RATE above SENS_AFBR_THRESH + SENS_AFBR_HYSTER and back to SENS_AFBR_S_RATE below SENS_AFBR_THRESH − SENS_AFBR_HYSTER
SENS_AFBR_HYSTER
1
Hysteresis in m around SENS_AFBR_THRESH
Release Notes
v1.16 - 3c45b562 - 2025-09-26
Migrate to build server
v1.16 - afb2c08b - 2025-08-06
AFBRS50: Fix long range measurement publishing
v1.16 - 2248a40e - 2025-07-10
v1.16 - d0bfa548 - 2025-06-12
v1.15 - 82ff8744 - 2025-06-11
Add DroneCAN RawIMU publisher
v1.16 - c8bed86b - 2025-02-26
Default to Long Range Mode (
SENS_AFBR_MODE= 1)Default to 5Hz output rate over 4m (
SENS_AFBR_L_RATE= 5)
v1.16 - 61036f77 - 2025-02-07
Update to AFBR 1.6.5 API
Improved distance sensor performance
Fix PAA3905 challenging surface detected spam
Only notify once every second
Last updated